Edge Cutting Double Sided PET Tape With Wire Trim is to attach a steel wire trim on a normal double sided PET tape. The double sided PET tape is coated with solvent acrylic adhesive. Used to trim spray-on truck liner

 

• Cutting filament is always at the edge of the tape


• Various adhesive strengths allow WrapCut to be re-positioned


• Strong filaments cut through vinyl, carbon fiber, and even PPF with ease


• Leaves no residue behind

 

 

BENEFITS OF WRAPCUT

• Reduces the required skill level to apply wraps


• Eliminates the need for a knife and risk of surface damage


• Creates new possibilities such as overlapping vinyl surfaces

 

 

Application

Edge Cutting Double Sided PET Tape is used to trim many types of coatings. Here the application process is illustrated as WireTrim is used to trim a spray-on truck bedliner.

 

 

 

Application Process

Step One: Applying
Remove wax and silicone from a dirt free surface. Then apply WireTrim along all trim lines. For best results, notch tape to conform to tight corners and gently stretch the tape around curves.

 

Step Two: Masking & Scuffing
Apply PlazMask, our pre-folded masking film, or masking paper, then scuff right up to the wire edge. WireTrim is durable enough to withstand most prep work. WireTrim's patented technology makes it easy to work fast. The special adhesive permits repositioning if required.

 

Step Three: Spraying
Proceed to spray the pickup truck bed just as you would normally, directly over the WireTrim tape and any other masking products you used in preparation for the spray job.

 

Step Four: Cutting
Pull the wire through the coating to provide a clean finished edge at an angle that suits your style. Choose from standard or heavy duty wire to best suit your application. Always pull wire out as soon as possible after application.

 

Step Five: Finishing
Remove PlazMask or masking paper and tape to complete the trimming process. Our ProLine products feature a high tack adhesive, remove slowly to eliminate clean up.